!!!2016/07 Cisco Official News!!!
CCNP Security 300-207 SITCS:Implementing Cisco Threat Control Solutions Exam Questions Updated Today!

Instant Free Download 300-207 SITCS PDF & 300-207 SITCS VCE Dumps from Braindump2go.com!
100% Pass Guaranteed!
100% Real Exam Questions!

NEW QUESTION 31 – NEW QUESTION 40:

1.|2016/07 Latest 300-207 SITCS PDF & 300-207 SITCS VCE 251Q&As:http://www.braindump2go.com/300-207.html
2.|2016/07 Latest 300-207 SITCS Exam Questions PDF:https://drive.google.com/folderview?id=0B272WrTALRHcbTlPUnl0Q1JTTjQ&usp=sharing

QUESTION 31
Which Cisco monitoring solution displays information and important statistics for the security devices in a network?

A.    Cisco Prime LAN Management
B.    Cisco ASDM Version 5.2
C.    Cisco Threat Defense Solution
D.    Syslog Server
E.    TACACS+

Answer: B

QUESTION 32
Which three search parameters are supported by the Email Security Monitor? (Choose three.)

A.    Destination domain
B.    Network owner
C.    MAC address
D.    Policy requirements
E.    Internal sender IP address
F.    Originating domain

Answer: ABE

QUESTION 33
Which Cisco Security IntelliShield Alert Manager Service component mitigates new botnet, phishing, and web-based threats?

A.    the IntelliShield Threat Outbreak Alert
B.    IntelliShield Alert Manager vulnerability alerts
C.    the IntelliShield Alert Manager historical database
D.    the IntelliShield Alert Manager web portal
E.    the IntelliShield Alert Manager back-end intelligence engine

Answer: A

QUESTION 34
A network engineer can assign IPS event action overrides to virtual sensors and configure which three modes? (Choose three.)

A.    Anomaly detection operational mode
B.    Inline TCP session tracking mode
C.    Normalizer mode
D.    Load-balancing mode
E.    Inline and Promiscuous mixed mode
F.    Fail-open and fail-close mode

Answer: ABC

QUESTION 35
What is the correct deployment for an IPS appliance in a network where traffic identified as threat traffic should be blocked and all traffic is blocked if the IPS fails?

A.    Inline; fail open
B.    Inline; fail closed
C.    Promiscuous; fail open
D.    Promiscuous; fail closed

Answer: B

QUESTION 36
Which two practices are recommended for implementing NIPS at enterprise Internet edges? (Choose two.)

A.    Integrate sensors primarily on the more trusted side of the firewall (inside or DMZ interfaces).
B.    Integrate sensors primarily on the less trusted side of the firewall (outside interfaces).
C.    Implement redundant IPS and make data paths symmetrical.
D.    Implement redundant IPS and make data paths asymmetrical.
E.    Use NIPS only for small implementations.

Answer: AC

QUESTION 37
Which set of commands changes the FTP client timeout when the sensor is communicating with an FTP server?

A.    sensor# configure terminal
sensor(config)# service sensor
sensor(config-hos)# network-settings
sensor(config-hos-net)# ftp-timeout 500
B.    sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# network-settings parameter ftp
sensor(config-hos-net)# ftp-timeout 500
C.    sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# network-settings
sensor(config-hos-net)# ftp-timeout 500
D.    sensor# configure terminal
sensor(config)# service network
sensor(config-hos)# network-settings
sensor(config-hos-net)# ftp-timeout 500

Answer: C

QUESTION 38
What are two benefits of using SPAN with promiscuous mode deployment? (Choose two.)

A.    SPAN does not introduce latency to network traffic.
B.    SPAN can perform granular scanning on captures of per-IP-address or per-port monitoring.
C.    Promiscuous Mode can silently block traffic flows on the IDS.
D.    SPAN can analyze network traffic from multiple points.

Answer: AD

QUESTION 39
What are the initial actions that can be performed on an incoming SMTP session by the workqueue of a Cisco Email Security Appliance?

A.    Accept, Reject, Relay, TCPRefuse
B.    LDAP Verification, Envelope Sender Verification, Bounce Verification, Alias Table Verification
C.    Recipient Access Table Verification, Host DNS Verification, Masquerading, Spam Payload Check
D.    SMTP Authentication, SBRS Verification, Sendergroup matching, DNS host verification

Answer: A

QUESTION 40
Refer to the exhibit. What CLI command generated the output?
 

A.    smtproutes
B.    tophosts
C.    hoststatus
D.    workqueuestatus

Answer: B


!!!RECOMMEND!!!

Braindump2go 2016/07 New Cisco 300-207 Exam VCE and PDF 251Q&As Dumps Download:
http://www.braindump2go.com/300-207.html [100% 300-207 Exam Pass Promised!]

 

2016/07 Cisco 300-207 New Questions and Answers PDF:
https://drive.google.com/folderview?id=0B272WrTALRHcbTlPUnl0Q1JTTjQ&usp=sharing